Network Diagnostics; Ping - TP-Link T2500-28TC User Manual

4. If the port is 100Mbps and its connection status is normal, cable test can't get the length of the
cable.

17.4 Network Diagnostics

This switch provides Ping test and Tracert test functions for network diagnostics.

17.4.1 Ping

Ping test function, testing the connectivity between the switch and one node of the network,
facilitates you to test the network connectivity and reachability of the host so as to locate the
network malfunctions.
Choose the menu Maintenance→Network Diagnostics→Ping to load the following page.
The following entries are displayed on this screen:
Ping Config

Destination IP:
Ping Times:
Data Size:
Interval:
Ping Result

Here you can view the Ping result.
Figure 17-8 Ping
Enter the IP address of the destination node for Ping test. Both IPv4
and IPv6 are supported.
Enter the amount of times to send test data during Ping testing. The
default value is recommended.
Enter the size of the sending data during Ping testing. The default
value is recommended.
Specify the interval to send ICMP request packets. The default value
is recommended.
298