Table of Contents
Advertisement
NET ACCESS BROADBAND ROUTER W/4-PORT SWITCH USERS' MANUAL
R
OUTING
For each different subnet on your LAN, enter:
IP:
Netmask:
Gateway:
Interface:
Default Gateway:
Interface:
Routing Table
The routing table stores the routing information so that the Router knows how to
route the IP packets to the proper network.
72
Enter the (network/subnet) IP address to which you want
to route.
Enter the subnet mask of your Network IP address.
Enter the IP address of the gateway device linking your
network to the other network/subnet. The IP address
should be in the same subnet as your Router. If you are
using this device with the LAN-to-LAN function, the
gateway IP should be set as the IP address of the Router.
Select the port (LAN or WAN, etc.) that the routed packet
should pass through. Select Local Network if you are using
a separate router. If you are using the Router with the
LAN-to-LAN function, the Interface should be set as the
WAN port that connects you to the other subnet.
Click Insert to save the information to the routing table.
To delete this information, select it from the routing table
and click Delete.
Default gateway is an IP address that all packets are routed
to, when the device is unable to find a route match (the
destination IP address of the packet in the routing table).
Click Add Default Gateway to save the IP address of the
default gateway.
Select the port (LAN or WAN, etc.) interface where the
gateway is located.
Advertisement
Table of Contents
