Table of Contents
Advertisement
NET ACCESS BROADBAND ROUTER W/4-PORT SWITCH USERS' MANUAL
13. The Modem Initial Command dialog box appears.
Figure 4-12. Modem Initial Command dialog box.
Select your modem manufacturer, then select the model from the list provided.
Click OK (if your modem is not listed and you have a driver disk, click Have Disk...
to install your modem).
This setting configures the initial string of the asynchronous port on the
Router so that it will know how to communicate with your modem. If you
are using an analog modem and your modem is not included in the
selection list, Standard Modem will work (in most cases). If you are
using an ISDN TA, refer to the ISDN TA's User Guide for information on
the initialization and hang-up strings. Use Broadband Manager to enter
modem strings.
14. The Setup Wizard: Modem Setting dialog box re-displays.
Use the Asynchronous port settings list to select the baud rate. Select the DTE
speed (that is, the speed of communication between the asynchronous port of the
Router and the modem). For DCE speed compression modems, this value can
normally be set to about 4 times the speed of your modem. Keep in mind that if
you set the baud rate too high, the dial-up connection may fail.
34
NOTE
Advertisement
Table of Contents
