Table of Contents
Advertisement
8.4 Accessing a Windows NT Server and a Novell NetWare Server
Before configuring your remote site, make sure that TCP/IP has been
installed on your NT Server.
Perform the following procedures if your PC workstation needs to access both a
Windows NT Server and a Novel NetWare Server.
8.4.1 A
D
DDING THE
Windows 95/98/NT:
1. Click Start, Settings, Control Panel.
2. Double-click the Network icon to open the Network dialog box.
3. Click Add; the Select Network Component Type dialog box opens.
4. Select Adapter, then click Add. The Select Network adapters dialog box
opens.
5. Win95/98 only: In the Manufacturers box, select Microsoft. In the Network
Adapters box, select Dial-Up Adapter.
[Note: In Windows NT workstations, there is no Manufacturers box.]
6. Click OK (twice) to return to, and then close, the Network dialog box.
8.4.2 A
TCP/IP (N
DDING
Windows 95/98/NT:
1. In the Network dialog box, Configuration tab, click Add.
2. Select Protocol and click Add.
3. The Select Network Protocol dialog box is displayed. In the Manufacturers
box [Win95 only], select Microsoft. In the Network Protocols box, select
TCP/IP [Win95/98] or TCP/IP Protocol [WinNT only].
[Note: Windows NT workstation has no Manufacturers box.]
4. Click OK (twice) to return to, and then close, the Network dialog box.
-U
A
(N
IAL
P
DAPTER
/NT S
OVELL
CHAPTER 8: LAN Client Settings
NOTE
/NT S
OVELL
ERVER
C
ERVER
ONNECTION
C
)
ONNECTION
)
105
Advertisement
Table of Contents
