Table of Contents
Advertisement
5. Connect a network cable from the cable or DSL modem to the 10BASE-T
WAN port.
6. Connect the provided power supply cable to the 5-VDC power port on the
back of the router. Plug the power supply into an AC power outlet as shown
on the previous page.
7. Power on your DSL modem or cable.
8. If you are using an analog modem or ISDN TA, power on the device.
9. Press and hold the Router's Reset button for 3 seconds to restore the default
settings.
You are ready to configure software for your Router and network PCs.
CHAPTER 3: Hardware Installation
19
Advertisement
Table of Contents
