Replacing The Unit; Replacing The 2Nd Image Transfer Roller Unit; Replacing The Image Transfer Belt Unit - Konica Minolta bizhub C250 Service Manual

Field Service Ver. 3.0 Aug. 2006
3.6

Replacing the unit

3.6.1

Replacing the 2nd Image Transfer Roller Unit

[2]
[2]
3.6.2

Replacing the Image Transfer Belt Unit

A. Removal Procedure
1. Open the Front Door and turn OFF the Main Power Switch.
2. Remove the Waste Toner Box
See P.28
3. Slide out the Imaging Unit (C/M/Y/K).
See P.36
NOTE
• After the Imaging Unit has been removed from the main unit, be sure to place it in
the plastic bag (black) or wrap it in a light shielding cloth, and store it in a dark
place.
Do not leave the Imaging Unit exposed to light for a extended period of time, as it
may become damaged.
A. Removal Procedure
1. Open the Front Door and turn OFF
the Main Power Switch.
2. Open the Right Door.
3. Unlock the Lock levers [1] (at two
places).
4. Holding onto the Lock levers [1] (at
[1]
two places), remove the 2nd Image
Transfer Roller Unit [2].
4038F2C021DA
B. Reinstallation Procedure
1. Holding onto the Lock levers [1] (at
two places), mount the 2nd Image
Transfer Roller Unit [2].
2. Lock the Lock levers [1](at two
places).
3. Close the Right Door.
[1]
NOTE
• Make sure that the door is locked in
position both at front and rear.
4. Turn ON the Main Power Switch.
5. Close the Front Door.
4038F2C022DA
NOTE
• The 2nd Image Transfer Roller Unit
is supplied with the Transfer Belt
Unit.
Replace it when replacing the
Transfer Belt Unit.
3. Periodical check
31