Konica Minolta bizhub C250 Service Manual page 833

Hide thumbs Also See for bizhub C250:

Table of Contents

9J08F2C517DA

9J08F2C531DA

Field Service Ver. 1.0 Aug. 2006

3. Measure the width of Y and Z (clear-

ance of the exterior parts) on front

and back side.

Specifications:

Y = Z - 1 mm

(Y must be smaller than Z)

Z = 7 ± 2 mm (front side)

Z = 9 ± 2 mm (back side)

• To measure the front side, open the

front door and measure it using fin-

isher side as supporting point refer-

ring showed on the illustration left.

4. When the value does not fall within

the specified range, remove the tray

unit and pull up the casters to adjust

• For adjusting the casters, hold the

bottom part of the stand table and

turn the adjusting bolt [1].

Chapters

Table of Contents