Konica Minolta bizhub C250 Service Manual page 254

Field Service Ver. 3.0 Aug. 2006
<Media Adjustment>
Functions • Adjust the 2nd image transfer output (ATVC) on the 1st page and the 2nd page for
each paper type.
• This function is provided to open [Transfer Output Fine Adjustment] → [2nd Transfer
Adjust] of Service Mode up to Administrator and the fine-adjusted value is reflected in
the Service Mode setting.
Use • To use when the transfer failure at the trailing edge occurs.
Adjustment
Specification
Adjustment To increase the ATVC value (in the direction of a foggier image):
Instructions increase the setting value in + direction.
To decrease the ATVC value (in the direction of a less foggy image):
increase the setting value in - direction.
Setting/ 1. Call the Administrator Setting to the screen.
2. Touch these keys in this order: [Expert Adjustment] → [Printer Adjustment] → [Media
Procedure
Adjustment].
3. Select the side of the image (Front side or Back side), on which the transfer failure at
the trailing edge occurs.
4. Select the paper type with the transfer failure at the trailing edge.
5. Enter the new setting from the [+/-].
6. Touch [OK] to validate the adjustment value.
7. Check the copy image for any image problem.
<Erase Leading Edge>
• It will be displayed only when the following setting is set to "Level 2".
[Service Mode] → [Enhanced Security] → [Administrator Feature Level]
Functions • To set the leading edge erase amount of the paper.
Use • To change the width of the area not printed along the leading edge of the paper.
Setting/ • The default setting is "4 mm".
Procedure
(3) Finisher Adjustment
2
• For details of adjustment method, see FS-603 or FS-514 Service Manual.
See P.26 of the FS-603 service manual.
See P.26 of the FS-603 service manual.
"0" (-5 to +5)
"4 mm" 5 mm
8. Utility Mode
7 mm
211