Konica Minolta bizhub C250 Service Manual page 367

10. Service Mode
10.7.4 Setup confirmation
• Follow the steps below to make sure that CS Remote Care has been properly set
up.
1. Call the Service Mode to the screen.
2. Touch [CS Remote Care].
3. Check to make sure that only selected item is displayed.
10.7.5 Calling the Maintenance
• When CE starts maintenance, inputting the ID code of CE (seven digits: numbers which
CE can identify. They are controlled by the distributor.) will transmit the information to the
Center side and tells that the maintenance has started. When the maintenance is fin-
ished, touching [Maintenance Complete] key will transmit the information to the Center
and tells that it is finished.
A. When starting the Maintenance
1. Select Service Mode and touch [CS Remote Care].
2. Touch [ID Code], and input ID Code.
3. Touch [ID Coke].
* The Start key blinks while maintenance is being carried out.
B. When finishing the Maintenance
1. Select Service Mode and touch [CS Remote Care].
2. Touch [Maintenance Complete].
10.7.6 Calling the Center from the Administrator
• When the CS Remote Care setup is complete, the administrator can call the CS Remote
Care center.
1. Select [Administrator Setting], and touch [System Connection].
2. Touch [Admin. transmission].
3. Press the Start key.
When the setup is not complete or another transmission is being carried out, the
Admin. transmission key will not be displayed, and the transmission is not available.
NOTE
• For transmitting data of the machine by calling the center on the specified date
and time, refer to the manual for CS Remote Care Center.
10.7.7 Checking the transmission log
• The transmission log list will be output to be checked.
1. Select [Service Mode] → [CS Remote Care], and touch [Detail setting].
2. Touch [Communication Log Print].
3. Load Tray 1 or Bypass tray with A4S paper.
4. Press the Start key to output transmission log.
324
Field Service Ver. 3.0 Aug. 2006