Konica Minolta bizhub C250 Service Manual page 980

Field Service Ver. 1.0 Jul. 2005
2.3.20 Finisher Control Board
[1]
[3]
2.3.21 Punch Control Board
[2]
[1]
2.3.22 Transport Motor Unit
[4]
[4]
[2]
2.3.23 Middle Transport Motor
[3]
[1]
[2]
[2]
4583fs2592c0
[3]
[2]
[2]
[1]
[2]
4583fs2591c0
[4]
[5]
[1]
[3]
4583fs2574c0
[3]
4583fs2580c0
1. Remove the Rear Cover.
See P.7
2. Disconnect all connectors on the
Board, and remove the screw [1].
3. Release the PCB support [2], and
remove the Finisher Control Board
[3].
1. Remove two screws [1].
2. Disconnect seven connectors [2],
and remove the Punch Control
Board [3].
1. Remove the Rear Cover.
See P.7
2. Disconnect the connector [1].
3. Remove screw [2], and remove the
Harness Guide [3].
4. Remove three screws [4], and
remove the Transport Motor Unit [5].
1. Remove the Middle Rear Cover.
See P.10
2. Remove the harness from the Wire
Saddle [1].
3. Disconnect the connector [2].
4. Remove two screws [3].
2. Other
21