Resetting The Settings Of The Camcorder To The Standard Settings Saved In The Reference File - Sony PDW-510 Operation Manual

The camcorder returns to the settings before selecting
this scene file.
To load a scene file saved in the "Memory Stick"
Proceed as follows.
1 Turn the MENU knob to move the b mark to
"SCENE RECALL", and press the MENU knob.
The P00 SCENE RECALL page appears.
?P00 SCENE RECALL
DISPLAY MODE
MEM<1>:STANDARD
MEM<2>:STANDARD
MEM<3>:STANDARD
MEM<4>:STANDARD
MEM<5>:NO FILE
2 Turn the MENU knob until the page which
contains the desired file number appears, then press
the MENU knob.
3 Turn the MENU knob to move the b mark to the
desired file number, and press the MENU knob.
The message "RECALL OK? YES bNO"
appears.
P01 SCENE RECALL
RECALL OK?
DISPLAY MODE
001.SCENE1
002.SCENE2
003.NO FILE
004.SCENE4
005.SCENE5
***.5FILE LOAD
4
To carry out the recall, move the b mark to "YES" and
press the MENU knob.
To cancel, press the MENU knob leaving the b mark
pointing to "NO".
When the loading is completed, the message
"COMPLETE" appears. The camcorder is set up
according to the loaded scene file.
If no file is present with a particular file number, this
is shown as "NO FILE".
5
To end the menu operation, set the MENU ON/OFF
switch to OFF or close the cover of the menu operating
section.
Loading scene files from a "Memory Stick"
into the camcorder memory
You can load up to five scene files stored in the "Memory
Stick" into the camcorder memory in a single operation.
ESC
: F.ID
ESC
YES NO
: ALL
MEM1-5
1
After displaying the SCENE FILE page (see page
154), turn the MENU knob to move the b mark to
"SCENE RECALL", and press the MENU knob.
A SCENE RECALL page appears.
2
Turn the MENU knob until the SCENE RECALL
page which contains the desired scene files appears,
then press the MENU knob.
3
Turn the MENU knob to move the b mark to "5FILE
LOAD b MEM 1-5", and press the MENU knob.
The message "RECALL OK? YES bNO" appears.
P01 SCENE RECALL
RECALL OK?
DISPLAY MODE
001.SCENE1
002.SCENE2
003.NO FILE
004.SCENE4
005.SCENE5
***.5FILE LOAD
4
To carry out the recall, move the b mark to "YES" and
press the MENU knob.
To cancel, press the MENU knob leaving the b mark
pointing to "NO".
When loading is complete, the message
"COMPLETE" appears and the access indicator goes
off.
5
To end the menu operation, set the MENU ON/OFF
switch to OFF or close the cover of the menu operating
section.
Notes
• The scene files loaded from the "Memory Stick"
overwrite data saved in the camcorder memory.
• To load the scene file saved in the camcorder memory
when the "Memory Stick" is inserted, return to the P00
SCENE RECALL page and load the desired scene file in
the camcorder memory.
• When there is no file to be loaded (shown as "NO
FILE"), an existing file of the same number is
unaffected. In the example shown in step 3, MEM(3) is
not overwritten.
8-2-3 Resetting the Settings of the
Camcorder to the Standard
Settings Saved in the
Reference File
You can reset the settings of the camcorder to the settings
saved in the reference file (standard settings).
ESC
YES NO
: ALL
MEM1-5
8-2 Saving and Loading Scene Files
155