Operation Warnings - Sony PDW-510 Operation Manual

10-3 Operation Warnings

When a problem occurs at power on or during operation, a
warning is given by the relevant indicators on the color and
monochrome LCDs, in the viewfinder and on the
Alarm Indicators on color/
Message monochrome LCDs
Warning/
Battery
status
indication
–
1)
E**-**
MEM Full –
ILL.REC! –
Disc Error! –
HUMID! –
Before DISC
8)
Full
DISC DISC and
6) E
FULL!
LOW BATT
8)
BATT!
BATT BATT and
EMPTY! E
High –
TEMP!
180
10-3 Operation Warnings
Indicators in viewfinder/
on camcorder body
Flashing/
:Continuous
continuous
:4 flashes/s
WARNING REC/tally BATT
–
– 2) 2)
– 2) 2)
– 2) 2)
Continuous 2) 2)
4) 2) 2)
Flashing
5) 6) 6)
Flashing
4) 7)
Flashing
5)
Flashing
–
camcorder body. The speaker and earphone also give
audible warnings.
Operation warnings
Warning Problem
sounds
:
:1 flash/s
4 beeps/s
:
1 beep/s
:
Continuou
s beep
– Recording
error
– 2) Shockproo
f memory
overflow
– 2) Input sync
error
– 2) A disc
defect was
detected.
2) Condensa-
tion on the
3)
optical
pickup.
2) Disc
almost full.
6) Disc full.
7) Battery
almost
exhausted.
Battery
exhausted.
– Internal
temperatur
e high.
VDR Action to take
operation
Recording Turn off the power
stops. and consult your
Sony representative.
Recording Protect the unit from
continuous but shocks and vibration.
may be
substandard.
Recording Turn off the power
continuous but and contact your
may be Sony service
substandard. representative. (This
indication may be
given momentarily
when a GENLOCK
signal is connected or
disconnected, but this
does not indicate a
problem.)
Recording If defects are
continues, detected repeatedly,
avoiding the exchange the disc.
defect, but
may be
substandard.
Recording/ Stop recording/
playback playback, turn off the
continues but power, then turn it on
stops when an again, and wait until
error occurs the HUMID indicator
on the drive. disappears.
Operation Be prepared to
continues. change the disc.
Recording Change the disc.
stops.
Operation Change the battery.
5)
continues.
Operation Change the battery.
stops.
Operation Power the unit off and
continues. move it to a cool
place.