Display Modes And Setting Change; Messages; Setting The Marker Display; Confirmation/Adjustment Progress Messages - Sony PDW-510 Operation Manual

5
To set another item to "ON" or "OFF", repeat steps 3
and 4.
6
To end the menu operation, set the MENU ON/OFF
switch to OFF or close the cover of the menu operating
section.
7-2-3 Display Modes and Setting
Change Confirmation/
Adjustment Progress

Messages

You can limit or suppress the messages that give details of
setting changes and adjustment progress and results by
setting a display mode.
The conditions under which messages are displayed and
their correspondence with the display mode are as follows:
Setting change confirmation/adjustment progress messages
and display modes
Y: Message is displayed.
N: Message is not displayed.
Message Message
display
condition
When the filter ND : n, CC : m (where n =
selection has 1, 2, 3, 4, m = A, B, C, D)
been changed
When the gain GAIN : n (where n = -3dB,
setting has been 0dB, 3dB, 6dB, 9dB,12dB,
changed 18dB, 24dB, 30dB, 36dB,
42dB, 48dB)
When the WHITE : n (where n = A
setting of the CH, B CH, PRESET) or
WHITE BAL ATW : RUN
switch has been
changed
When the DCC : ON (or OFF)
OUTPUT/DCC
selector has
been set to DCC
ON or OFF
When the SS : 1/100 (PDW-510/530)
shutter speed or 1/60 (PDW-510P/530P)
and mode (or 1/125, 1/250, 1/500,
setting has been 1/1000, 1/2000,ECS, SLS)
1)
changed
When the black E.g. WHITE : OK
or white balance
has been
adjusted
1) This is also displayed for about 3 seconds when the SHUTTER selector is
set to ON.
Changing the display mode
The currently set display mode appears on the VF DISP 1
page of the USER menu. To change it, proceed as follows.
1
Follow steps 1 and 2 in 7-2-2 "Selecting the Display
Items" on page 126, until the VF DISP 1 page of the
USER menu appears on the screen.
2
Turn the MENU knob to move the b mark to "VF
DISPLAY MODE", and press the MENU knob.
The b mark on the left of "VF DISPLAY MODE"
changes to a z mark and the z mark on the left of the
setting changes to a ? mark.
3
Turn the MENU knob until the desired display mode
appears, and press the MENU knob.
The z mark changes to a b mark and the ? mark
changes to a z mark.
4
To end the menu operation, set the MENU ON/OFF
switch to OFF or close the cover of the menu operating
section.
Display
mode

7-2-4 Setting the Marker Display

setting
1 2 3
Use the MARKER 1 page of the USER menu to switch the
N N Y
display of the center and safety zone markers on or off and
to select whether the area indicated by the safety zone
marker is 80%, 90% or 100% of the screen area.
N N Y
N N Y
N Y Y
MENU knob
1
Set the MENU ON/OFF switch to ON.
N Y Y
The last accessed menu page appears on the screen.
2
Turn the MENU knob until the MARKER 1 page
appears, and press the MENU knob to select the page.
N Y Y
CANCEL/PRST /
ESCAPE switch
MENU ON/OFF switch
7-2 Status Display on the Viewfinder Screen
127