Resetting The Settings Of The Camcorder To The Standard Settings Saved In The Reference File - Sony PDW-530 Operation Manual

Loading scene files from a "Memory Stick"
into the camcorder memory
You can load up to five scene files stored in the "Memory
Stick" into the camcorder memory in a single operation.
1
After displaying the SCENE FILE page (see page
109), turn the MENU knob to move the b mark to
"SCENE RECALL", and press the MENU knob.
A SCENE RECALL page appears.
2
Turn the MENU knob until the SCENE RECALL
page which contains the desired scene files appears,
then press the MENU knob.
3
Turn the MENU knob to move the b mark to "5FILE
LOAD b MEM 1-5", and press the MENU knob.
The message "RECALL OK? YES bNO" appears.
P01 SCENE RECALL
RECALL OK?
DISPLAY MODE
001.SCENE1
002.SCENE2
003.NO FILE
004.SCENE4
005.SCENE5
***.5FILE LOAD
4
To carry out the recall, move the b mark to "YES" and
press the MENU knob.
To cancel, press the MENU knob leaving the b mark
pointing to "NO".
When loading is complete, the message
"COMPLETE" appears and the access indicator goes
off.
5
To end the menu operation, set the MENU ON/OFF
switch to OFF or close the cover of the menu operating
section.
Notes
• The scene files loaded from the "Memory Stick"
overwrite data saved in the camcorder memory.
• To load the scene file saved in the camcorder memory
when the "Memory Stick" is inserted, return to the P00
SCENE RECALL page and load the desired scene file in
the camcorder memory.
• When there is no file to be loaded (shown as "NO
FILE"), an existing file of the same number is
unaffected. In the example shown in step 3, MEM(3) is
not overwritten.
ESC
YES NO
: ALL
MEM1-5
7-2-3 Resetting the Settings of the
Camcorder to the Standard
Settings Saved in the
Reference File
You can reset the settings of the camcorder to the settings
saved in the reference file (standard settings).
For details about the items in the reference file, refer to the
Maintenance Manual.
On the SCENE FILE page, turn the MENU knob to move
the b mark to "STANDARD", and press the MENU knob.
F04 SCENE FILE
s1 :SCENE 25
s2 :SCENE 26
s3 :SCENE 27
s4 :SCENE 28
s5 :NO FILE
xSTANDARD
SCENE RECALL
SCENE STORE
F.ID: SCENE21
The s displayed on the left of STANDARD changes to x.
When x changes to s, the settings of the camcorder are
reset to the settings saved in the reference file.
If you press the MENU knob again while x is displayed,
the operation is canceled and the camcorder returns to the
settings before STANDARD was selected.
TOP
: EXEC
: EXEC
7-2 Saving and Loading Scene Files
111