Download  Print this page

Attaching A Uhf Portable Tuner - Sony PDW-510 Operation Manual

Hide thumbs

Advertisement

Screws removed
in step 1
CAC-12
3
Open the CAC-12 and remove the microphone
adaptor.
Open the CAC-12.
Loosen the screw.
1) Attach the microphone adaptor when using a small-diameter external
microphone.
4
Place an electret condenser microphone in the CAC-
12.
Close the CAC-12.
Tighten the screw.
5
Connect the microphone cable to the AUDIO IN CH1
or AUDIO IN CH2 connector. Set the switches as
described in the section "Switch settings when using
an external microphone" (see page 166).
Microphone
1)
adaptor
ECM-672 or
similar
microphone
m
Note
When you detach the CAC-12 Microphone Holder
once you have attached to the camcorder, be careful
not to lose the two screws fixing the CAC-12. After
detaching the CAC-12, be sure to put the two screws
back into their original places (see the figure
illustrating the step 1 operation).
9-5-3 Attaching a UHF Portable
Tuner (for a UHF Wireless
Microphone System)
To use a Sony UHF wireless microphone system, fit one of
the following UHF portable tuners.
• WRR-855A/855B UHF Synthesized Tuner Unit
• WRR-862 UHF Portable Tuner.
For each of these UHF portable tuners, use the following
attachment procedure.
For details, refer to the UHF portable turner manual.
Fitting the WRR-855A/855B
You can use the WRR-855A/855B UHF Synthesized
Tuner Unit simply by inserting it into the slot in the
camcorder, and fastening the fixing screws.
1
Undo the four fixing screws holding the cover of the
slot, and remove the cover.
2
Insert the WRR-855A/855B, and fasten the four fixing
screws.
167
9-5 Audio Input System

Advertisement

Table of Contents

   Related Manuals for Sony PDW-510

This manual is also suitable for:

Pdw-510pPdw-530pPdw-530

Comments to this Manuals

Symbols: 0
Latest comments: