Table of Contents
Advertisement
4-8-3 Display Mode and Setting Change and
Adjustment Progress Messages
You can limit or suppress the messages that give details of setting
changes and adjustment progress and results by setting a display mode.
The conditions under which messages are displayed and their
correspondence with the display mode are as follows:
Setting change and adjustment progress messages and display modes
Message display
condition
When the filter selection
has been changed
When the gain setting
has been changed
When the setting of the
WHITE BAL switch has
been changed
When the OUTPUT/
DCC selector has been
set to DCC ON or OFF
Message
FILTER : n (where n = 1, 2, 3,
4)
GAIN : n (where n = –3dB,
0dB, 3dB, 6dB, 9dB,12dB,
18dB, 24dB, 30dB, 36dB,
42dB, 48dB)
WHITE : n (where n = A CH,
B CH, PRST) or ATW : RUN
DCC : ON (or OFF)
Chapter 4 Adjustments and Settings for Recording
Y: Message is displayed.
N: Message is not displayed.
Display mode
setting
1
N
N
N
N
4
2
3
N
Y
N
Y
N
Y
Y
Y
(Continued)
4-61
Advertisement
Table of Contents
