Mitel 5320 User Manual page 60

.
Final
The system connects you with the caller who was on hold at the park
location. The LCD screen now displays the caller's name (if known) or
number.
Robin Jones
TRANS CONF
To cancel the retrieval of the parked call, press the QUIT softkey.
If you enter a park location where there is no caller on hold, the phone
LCD will briefly display "No Parked Call".
There are nine park locations available (1 through 9). If all park locations
are in use when you try to park a call, the phone LCD will briefly display
"Park Locations Full" and the call will be placed on hold.
If the call is left parked for 30 seconds, the phone of the person who
parked the call will beep and the phone's LCD will briefly display "Call
parked at: " with the park location number to remind you that the call has
not been retrieved.
Speaker on the 5224/5324 phone
Using Speaker, you can turn the speakerphone on your phone on and off. To
use Speaker, press the
Transfer call on the 5224/5324 phone
Using Transfer, you can transfer a call from one phone to another. To transfer
a call, follow these steps:
1 While on an active call, press the TRANS softkey. The system places the
call on hold, and the LCD screen displays:
Transfer To:
DIR
2 Enter the extension or phone number of the person to whom you want to
transfer the call, or press a One-Touch Speed Dial key, or press a Line
Appearance key that has a call on hold.
Transfer To:415
3 Press the TRANSFER softkey once you hear ringing. You can also press
the TRANSFER softkey after the additional party has answered. The LCD
screen displays the message "Transfer Complete" for approximately five
seconds before returning to an idle state.
If you enter an invalid extension during a transfer, the LCD screen displays
"Invalid Extension". To reconnect with the caller, follow these steps:
1 Press the END softkey.
2
Press the flashing Line Appearance key.
END
key.
QUIT
QUIT
Using the phone system 55