Mitel 5320 User Manual page 107

102 Using the phone system
You are no longer connected with the caller and your phone returns to the
idle state.
To retrieve a parked call, follow these steps:
1
From an idle phone, lift the handset. This will select the next available
Line Appearance. Select a memory key programmed with the Park/
Retrieve feature. The phone LCD screen displays:
Park Location:
2
Enter the required park location using the phone keypad.
The system connects you with the caller who was on hold at the park
location. The LCD screen now displays the caller's name (if known) or
number.
Robin Jones
To cancel the retrieval of the parked call, replace the handset.
If you enter a park location where there is no caller on hold, the phone
LCD will briefly display "No Parked Call".
There are nine park locations available (1 through 9). If all park locations
are in use when you try to park a call, the phone LCD will briefly display
"Park Locations Full" and the call will be placed on hold.
If the call is left parked for 30 seconds, the phone of the person who
parked the call will beep and the phone's LCD will briefly display "Call
parked at: " with the park location number to remind you that the call that
you parked has not been retrieved.
Speaker on the 5304 phone
To use the speaker on your phone, select a Line Appearance key while the
handset is on-hook. Note that since there is no handsfree microphone, this
effectively mutes the call.
Final