Securitytec DS-8004HCI-S User Manual page 87

be active. If you select low sensitivity, such as 0, a great deal of image movement
is required to generate a motion alarm. A high sensitivity setting (like 5) will
respond to smaller motions within images. The default sensitivity is 2. You may
have to test different sensitivity levels in order to find the appropriate settings for
some cameras.
4. Motion area setup: You must define motion areas so that DVR will response
when there is motion in those areas. Move the ―Active Window‖ to the ―Area‖
button on the right side of sensitivity selection box and press [ENTER] to enter the
―Motion Area Setup‖ interface.
The screen is divided into 22*15 panes (22*15 PAL). There is one yellow panel on the
upper left side. The motion area setup steps are the same as that of mask area setup
(refer to chapter 6.6). The only differences are that you can use the [PTZ] key to set the
whole screen as a motion area. Multi motion areas can be defined.
5. Setup multi areas: After you setup one motion area, press the [EDIT] key.
The yellow pane will appear again allowing another motion box selection.
6. Clear part of motion area: Move the yellow pane near the start position of the
area you want to clear. Press [EDIT] and the yellow pane will turn black. Use the
[↓] [→] keys to enlarge or shrink the black area. Press the [EDIT] key to
clear this part motion area.
7. Press [Enter] to save the changes, or [ESC] to cancel.
87