Securitytec DS-8004HCI-S User Manual page 34

Direction Keys
12
ENTER
13 PTZ
14 ESC
15 Reserved
16 F1
17 Lens control
18 F2
Loading the batteries into the IR controller:
1. Remove the battery cover.
2. Insert the battery. Ensure that the poles (+ and -) are correctly positioned.
3. Replace the battery cover.
Enable the IR Remote Controller:
1. Press the [DEV] key, input the DVR device ID (default is ―88‖. It can be changed in
the ―Display‖ menu) and then press the [ENTER] key.
2. The ―STATUS‖ lamp on the DVR front panel will turn green, indicating that you can
use IR controller to operate the DVR.
Disable the IR controller:
1. When IR controller status lamp is on, press the [DEV] key.
2. The ―STATUS‖ lamp on the DVR will turn off. The IR controller won't control the
DVR.
Turn off the DVR:
1. When IR controller status is on, press the [POWER] key for several seconds.
2. The DVR will be powered off.
Troubleshooting the IR Remote:
1. Always aim the IR Remote controller at the DVR you want to control.
2. Make sure that the correct DVR ID code is entered and the status lamp on the
DVR is green.
3. Check the batteries.
4. Make sure nothing is obstructing the IR sensor on the DVR.
5. Try another IR Remote control.
Note: If you have only one Remote unit to work with it is often difficult to verify whether the
Same as direction keys and enter
key on front panel
Same [PTZ] key on front panel
Same as [ESC] key on front panel
Reserved for future use
Same as [F1] key on front panel
IRIS, FOCUS ZOOM for lens
control
Same as [F2] key on front panel
34