Chapter4 Basic Operation Guide; Power On - Securitytec DS-8004HCI-S User Manual

Chapter4 Basic Operation Guide

4.1

Power on

Note: It is always a good idea to check the power supply before connecting the AC
cable and applying power. The DS8000 is equipped with a universal power supply that will
accommodate 120/240VAC, 50/60Hz. Units with an input power selector switch must be
placed in the correct input voltage position for the local area before applying power.
Switch the main power switch off before inserting the AC power cord. Connect a monitor
(VGA, or composite) to view the GUI and setup the unit.
If the [POWER] lamp is off, please do as follows:
1. Make sure the power cord is connected to an active power source.
2. Switch on the power key on the real panel.
If the [POWER] lamp is red:
1. Press the [POWER] key to start the DVR.
2. The power lamp will turn green as the unit powers up.
3. The DSP and HDD initialization process will be shown on the monitor.
The graphic includes two lines. The first line indicates the DSP hardware and the
second lists the available drives installed. A check mark (√) indicates correct
operation of the DSP and the presence of a disk drive installed in one of the eight
available drive locations. An ―X‖ indicates improper operation or an uninstalled
drive.
Note: If no drives are installed or detected, a ―No Disk‖ message will display.
43