Removing A Raid Adapter Battery/Flash Power Module - IBM System x3650 M5 Installation And Service Manual

Removing a RAID adapter battery/flash power module

Use this information to remove a RAID adapter battery/flash power module.
About this task
If a RAID adapter battery / flash power module is installed near the fan cage and
you need to replace it, complete the following steps:
Procedure
1. Read the safety information that begins on "Safety" on page vii and
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the top cover (see "Removing the top cover" on page 146).
4. Disconnect the battery/flash power module cable from the RAID adapter
5. If the flash power modules are located behind the full-height, full-length
6. ▌1▐Press the release tab and ▌2▐grasp the battery/flash power module out of
Figure 128. RAID adapter battery/flash power module removal
7. If you are instructed to return the RAID adapter battery/flash power module,
198
System x3650 M5 Type 5462: Installation and Service Guide
"Installation guidelines" on page 283.
battery/flash power module connector.
adapters, you need to remove the riser-card assemblies first. See "Removing an
adapter in a riser-card assembly" on page 185.
the holder.
Release latch
1
2
Raid adapter battery /
flash power module
follow all packaging instructions, and use any packaging materials for shipping
that are supplied to you.
Air baffle