Replacing The Rear Two Hard-Disk-Drive Kit - IBM System x3650 M5 Installation And Service Manual

Replacing the rear two hard-disk-drive kit

Use this information to replace the rear two hard-disk-drive kit on the system
board.
About this task
Note: Please refer to the following rules before you install the rear two
hard-disk-drive kit.
v 2.5-inch hot-swap hard disk drive model
v 3.5-inch hot-swap hard disk drive model
To install the rear two hard-disk-drive kit, complete the following steps:
Procedure
Figure 133. 2.5-inch rear two hard-disk-drive kit installation
202
System x3650 M5 Type 5462: Installation and Service Guide
– Supports one 2.5-inch rear two hard-disk-drive kit
– Supports one 2.5-inch rear two hard-disk-drive kit, or
– Supports two 2.5-inch rear two hard-disk-drive kits, or
– Supports one 2.5-inch rear two hard-disk-drive kit and one 3.5-inch rear two
hard-disk-drive kit
1. Read the safety information that begins on "Safety" on page vii and
"Installation guidelines" on page 283.
2. Turn off the server and peripheral devices and disconnect all power cords.
3. Remove the top cover (see "Removing the top cover" on page 146).
4. Align the rear two hard-disk-drive kit with the connector on the system board
and align it with the slots on the chassis; then, lower it into the server and
press down firmly until the rear two hard-disk-drive kit is seated correctly in
the connector on the system board
v 2.5-inch rear two hard-disk-drive kit installation
2.5-inch rear two
hard-disk-drive kit 1