Datamax Iclass Operator's Manual page 58

Communications (continued)
Menu Item
SNMPTRAP DESTINATION
000.000.000.000
IP DISCOVERY
ENABLED
DISABLED
SNMP
ENABLED
DISABLED
ADVANCED
TELNET
ENABLED
DISABLED
FTP
ENABLED
DISABLED
48
Specifies the SNMP Trap Address, where:
Is the address in standard octet format where SNMP
traps will be sent when SNMP service is installed on
your receiver.
Note: When zeroed, no traps are sent.
Controls IP Address discovery, where:
Broadcasts over the network at startup to receive
addresses from the responsible server. Manual
modifications to IP Address, Subnet Mask, or Gateway
are not allowed; and, if no server is found, the
specified static value will be used.
A server assigned IP address takes
precedence over any static address stored
in the interface.
WARNING
Uses the stored static IP, Subnet Mask, and / or
Gateway Address.
Allows management protocols, where:
Sends messages to SNMP-compliant devices.
Sends no messages.
Sets advanced networking functions and parameters,
where:
Sets Telnet protocol to transfer data, where:
Allows Telnet.
Disables Telnet.
Sets File Transfer Protocol to transfer data, where:
Allows FTP.
Disables FTP.
Details
I-Class