Datamax Iclass Operator's Manual page 101

Fault Messages (continued)
Displayed Message
CUTTER FAULT
DMA FAULT
GAP MODE
CANNOT CALIBRATE
GAP MODE
FAULTY SENSOR
I-Class
Fault Messages
Description
The printer has detected
a cutter mechanism
fault.
The printer has detected
a Direct Memory Access
failure.
Consistently low sensor
readings were detected.
Consistently high sensor
readings were detected.
Action(s)
WARNING! Use extreme
care. Turn OFF and unplug the
printer before proceeding.
Examine the cutter for
obstructions and ensure its cable
is properly connected.
Plug in and turn ON the printer.
Press the FEED Key. If the fault
does not clear, call for service.
Try cycling the printer power
OFF and ON. If the fault does
not clear, call for service.
Press any key to continue.
Ensure that media was inserted
in the sensor during the
appropriate calibration step; also
ensure that the sensor is clean.
Retry the calibration. If the
problem persists, try Advanced
Entry Calibration; see Section
5.2.2.
Press any key to continue.
Ensure that media was removed
from the sensor during the
appropriate calibration step; also
ensure that the sensor is clean.
Retry the calibration. If the
problem persists, call for service.
91