Datamax Iclass Operator's Manual page 100

Warning Messages (continued)
Displayed Message
LOW VOLTAGE
RTC RAM FAILURE
TEMPERATURE PAUSE
Fault Messages:
Fault Messages indicate a problem and appear on the LCD with the highest priority. If more
than one fault is detected, messages cycle. (Alternate messages may occur when
downloading font, firmware, or Boot Loader files.)
Note: To return operation after a fault occurs, the fault must be corrected and the
FEED Key pressed.
Displayed Message
24V OUT OF TOLERANCE
ADC FAULT
90
Warning Messages
Description
The printer has detected
a low operating voltage.
The printer was unable to
save settings in
permanent memory.
A high printhead
temperature has been
detected.
Fault Messages
Description
The printer has detected
a drop in the 24-volt
power supply.
The printer has detected
an analog to digital circuit
converter failure.
Action(s)
Possible low or fluctuating line
•
voltage level – Try moving
the printer to another AC
outlet; if the condition
persists, call for service.
If printing black over more
•
than 50% of the total label
area, try reducing the HEAT
setting or the size of the
black area.
Possible faulty main logic card. If
the condition persists, call for
service.
No action required. Printing will
resume after the printhead
cools.
Action(s)
Try cycling the printer power OFF
and ON. If the fault does not
clear, call for service.
Try cycling the printer power OFF
and ON. If the fault does not
clear, call for service.
I-Class