Loading Bios Defaults - QUANTA STRATOS S200 Series S200-X12TS Technical Manual

BIOS
Exit Fields (Continued)
S I O
ETUP TEM PTIONS
[<Device
String 4>]
[<Device
String 5>]
[<Device
String 6>]
H T C
ELP EXT OMMENTS
Boot with Device
<Device String 4>.
Boot with Device
<Device String 5>.
Boot with Device
<Device String 6>.

Loading BIOS Defaults

Different mechanisms exist for resetting the system configura-
tion to the default values. When a request to reset the system
configuration is detected, the BIOS loads the default system
configuration values during the next POST. The request to reset
the system to the defaults can be sent in the following ways:
A request to reset the system configuration can be gener-

ated by pressing <F9> from within the BIOS Setup utility.
A reset system configuration request can be generated by

moving the clear system configuration jumper.
BIOS settings are stored on NVRAM. Only the D4 setting uses
the CMOS. BIOS implements a mechanism to clear NVRAM
and CMOS. BIOS does not show CMOS error messages after
the CMOS has been cleared.
After clearing CMOS by battery or jumper, all variables in the
BIOS setup Menu load with the default values. BMC related
variables, like Set BMC LAN Configuration in BIOS setup
menu, are able to synchronize from BMC.
3-42
L BIOS D
OADING EFAULTS