Server Boot Issue Topics; System Does Not Boot After Initial Installation; Troubleshooting - QUANTA STRATOS S200 Series S200-X12TS Technical Manual

T
ROUBLESHOOTING

7.1. Troubleshooting

Server Boot Issue Topics

System does not Boot after initial installation:

Power Cord Not Plugged In

Processor Issues

Memory Issues

Monitor Issues

Power Supply, Chassis and Fan Issues

Cable Issues

Electrical Short or Overload

Defective Components

System does not boot after configuration changes:
Hardware Changes

Software Changes

BIOS Changes

Installation Problems

Troubleshooting External Connections

System does not Boot after Initial
Installation
Power Cord Not Plugged In
If the power supply cable is not plugged into the chassis power
connector, the system cannot boot up, even though chassis
front panel LEDs and the fan may be operational. Verify that the
power connections are good.
Processor Issues
Boot failure situations are also caused by the following:
Incompatible processor - ensure the selected processor model
is correct for your server board. If the processor is compatible,
try removing and reinstalling the processor to ensure it is
installed correctly.
Processor overheat-the system does not boot or shuts down
shortly after booting.
Ensure that the cooling fans are correctly installed and

running.
Ensure that the correct thermal interface material or the

thermal grease is applied to the processor.
7-1
T
ROUBLESHOOTING