Sun Microsystems Sun Fire V445 Server Administration Manual page 282

OpenBoot Configuration Variables Stored on a ROM Chip (Continued)
TABLE C-1
Variable Possible Values
ttyb-rts-dtr-off true, false
ttyb-ignore-cd true, false
ttya-rts-dtr-off true, false
ttya-ignore-cd true, false
baud-rate, bits, parity,
ttyb-mode
stop, handshake
ttya-mode 9600,8,n,1,-
output-device ttya, ttyb, screen
input-device ttya, ttyb, keyboard ttya
auto-boot-on- true, false
error?
load-base 0-n
auto-boot? true, false
variable-name
boot-command
variable-name
diag-file
variable-name
diag-device
variable-name
boot-file
variable-name
boot-device
use-nvramrc? true, false
variable-name
nvramrc
security-mode none, command, full
250 Sun Fire V445 Server Administration Guide • September 2007
Default Value Description
If true, operating system does not assert rts
false
(request-to-send) and dtr
(data-transfer-ready) on ttyb.
If true, operating system ignores carrier-
true
detect on ttyb.
If true, operating system does not assert rts
false
(request-to-send) and dtr
(data-transfer-ready) on serial management
port.
If true, operating system ignores carrier-
true
detect on serial management port.
ttyb (baud rate, number of bits, parity,
9600,8,n,1,
number of stops, handshake).
-
Serial management port (baud rate, bits, parity,
9600,8,n,1,
stop, handshake). The serial management port
-
only works at the default values.
Power-on output device.
ttya
Power-on input device.
If true, boot automatically after system error.
false
Address.
16384
If true, boot automatically after power on or
true
reset.
Action following a boot command.
boot
File from which to boot if diag-switch? is
none
true.
Device from which to boot if diag-switch? is
net
true.
File from which to boot if diag-switch? is
none
false.
Device(s) from which to boot if
disk net
diag-switch? is false.
If true, execute commands in NVRAMRC
false
during server start-up.
Command script to execute if use-nvramrc?
none
is true.
Firmware security level.
none