Powering Off The System Remotely - Sun Microsystems Sun Fire V445 Server Administration Manual

4. Press and release the Power button with a ball-point pen to power on the
system.
The power supply Power OK indicators light when power is applied to the
system. Verbose POST output is immediately displayed to the system console if
diagnostics are enabled at power-on, and the system console is directed to the
serial and network management ports.
Text messages appear from 30 seconds to 20 minutes on the system monitor (if one is
attached) or the system prompt appears on an attached terminal. This time depends
on the system configuration (number of CPUs, memory modules, PCI cards, and
console configuration), and the level of power-on self-test (POST) and OpenBoot
Diagnostics tests being performed. The System Activity indicator lights when the
server is running under control of the Solaris OS.

Powering Off the System Remotely

To issue software commands, you need to set up an alphanumeric terminal
connection, a local graphics monitor connection, ALOM system controller
connection, or a Tip connection to the Sun Fire V445 server. See
information about connecting the Sun Fire V445 server to a terminal or similar
device.
You can power off the system remotely either from the ok prompt or from the
ALOM system controller sc> prompt.
64 Sun Fire V445 Server Administration Guide • September 2007
Power button
Chapter 2 for more