Entering The Ok Prompt; To Enter The Ok Prompt - Sun Microsystems Sun Fire V445 Server Administration Manual

To reach the system console from the ALOM system controller, type the console
command at the sc> prompt. To reach the ALOM system controller from the system
console, type the system controller escape sequence, which by default is #. (pound
period).
For more information, see:
"About Communicating With the System" on page 26
"About the sc> Prompt" on page 32
"About the ok Prompt" on page 35
"Using the Serial Management Port" on page 41
Sun Advanced Lights Out Manager (ALOM) Online Help

Entering the ok Prompt

This procedure provides several ways of reaching the ok prompt. The methods are
not equally desirable. For details about when to use each method, see
Prompt" on page
Caution – Dropping the Sun Fire V445 server to the ok prompt suspends all
application and OS software. After you issue firmware commands and run
firmware-based tests from the ok prompt, the system might not be able to resume
where it left off.

To Enter the ok Prompt

1. If at all possible, back up system data before starting this procedure.
For information about the appropriate backup and shutdown procedures, refer to
Solaris system administration documentation.
2. Exit or stop all applications and warn users of the impending loss of service.
3. Decide which method you need to use to reach the ok prompt.
See
40 Sun Fire V445 Server Administration Guide • September 2007
35.
"About the ok Prompt" on page 35 for details.
"About the ok