Table of Contents
Advertisement
A
A
Wrench
B
Lock
C
Turn to adjust height
2. Extend or retract the feet.
Feet cannot be extended more than 228.6 mm (9 inches) from the projector bottom to the
bottom of feet. A safety hazard exists if loosening more than this amount. If more than 228.6
mm (9 inches) is needed to achieve the ~15° downward tilt, follow the steps in Installing the
extension feet (on page 48)
3. When the adjustment is correct, tighten the lock nut.
Installing the extension feet
Follow these steps to install the extension feet.
1. Loosen the six screws to remove the side-intake (right-side) cover.
2. Loosen the bottom nut from the baseplate.
3. Un-thread the entire 2x extensions from the baseplate and set aside.
4. Safely hold projector at least 304.8 mm (12 inches) off the surface, based on how high you
want to raise up the rear of projector to the maximum downward tilt of 15°.
5. Remove the 2x rear feet.
Unlock the lock nut with a wrench and thread both feet out of the foot holes.
6. Thread in both extensions into the rear threaded foot holes.
Make sure the small nut is threaded up to the big nut on the extensions.
7. Thread the 2x rear feet to bottom out into the lower nuts on the extension feet.
8. Adjust the heights of both extension feet to the required approximate length.
9. Prior to putting weight on projector, lock the foot nut up against the extension big nut.
Torque to 30in-lbs.
10. Lock the small extension nut up against the bottom of the projector.
Torque to 30in-lbs.
Cinema 2K-RBe Installation and Setup Guide–CP2406-RBe, CP2409-RBe, and CP2411-RBe
020-103907-01 Rev. 1 (03-2024)
Copyright
©
2024 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
B
C
Adjusting the image
48
Advertisement
Table of Contents
