Canon iR8500 Service Manual page 793

Hide thumbs Also See for iR8500:
Table of Contents

Advertisement

ERROR CODE
• Finisher (E500 to E514)
E500
Main cause
The finisher controller PCB is faulty (data communication with copier). The
DC controller PCB is faulty.
Condition
0000 The communication with the copier is disrupted and, in addition, is
E501
Main cause
The finisher controller PCB is faulty (data communication with the slave
CPU).
Condition
0000 The communication between the master CPU (IC106) and the slave
E503
Main cause
The saddle stitcher controller PCB is faulty. The finisher controller PCB is
faulty (data combination with the saddle).
Condition
0000 The communication between the saddle stitcher controller PCB
E505
Main cause
The EEPROM is faulty. The finisher controller PCB is faulty. The punch
driver PCB is faulty.
Condition
0001 The checksum of the EEPROM has an error (offset value error of
0002 The checksum of the EEPROM has an error (D/A conversion value
E-18
not recovered after 5 secs or retransmission. Or, the communica-
tion is disrupted and then recovered three times in 5 secs (This er-
ror is detected by the finisher).
CPU (IC125) is disrupted.
and the finisher controller PCB is disrupted.
aligning plate).
error in motor drive or sensor adjustment value).
COPYRIGHT© 2001 CANON INC.
2000 2000 2000 2000
CANON iR8500/7200 REV.1 AUG. 2001

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ir7200

Table of Contents