Canon iR8500 Service Manual page 715

SERVICE MODE
COPIER>FUNCTION
<INSTALL>
Use it at time of installation.
TONER-S
Use it to supply toner from the hopper to the developing assembly and to
stir the toner inside the developing assembly.
<Using the Mode>
1) Select the item, and press the OK key.
2) See that the machine supplies toner (about 8 to 10 min).
•
3) See that the machine automatically stops toner supply.
STRD-POS (Indicated if iR7200)
Use it to execute auto adjustment of the position of the CCD read position
for stream reading mode.
<Using the Mode>
1) Select this item, and press the OK key.
• Auto adjustment is executed.
2) See that the adjustment ends automatically.
3) Record the updated setting indicated in service mode on the service
label: COPIER>ADJUST>ADJ-XY>STRD-POS.
CARD
Use it to enter numbers for the card reader.
Input value
1 to 2001
Default: 0 (not connected)
As many as 1000 cards may be used (starting with the number entered; e.g.,
If the number entered is 1, cards between No. 1 and No. 1000 may be used.
If the number entered is 2001, cards between No. 2001 and 3000 may be
used.
S-72
• Before pressing the OK key, check to make sure that the developing
assembly is securely mounted.
• Do not turn off the power while machine is in operation.
While toner is being supplied, a count-down is indicated in sec starting
at 600 sec.
• Execute this mode at time of installing an ADF or if you have re-
moved and then installed the existing ADF.
COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON iR8500/7200 REV.1 AUG. 2001