Canon iR8500 Service Manual page 768

3 FEEDER
3.1 DISPLAY
FEEDSIZE
Use it to indicate the size of the original detected by the ADF.
3.2 ADJUST
DOCST
Use it to adjust the stopped position of original for pickup from the ADF
(original tray).
Memo
Range of (iR8500)
adjustment -30 to 30 (1 being equal to 0.5 mm)
<Using the Mode>
1) Place an original in the original tray.
2) Select the item, and change the setting; then, press the OK key.
3) Press the OK key so that the original will be picked up.
4) Open the ADF, and check the original stop position.
5) Press the OK key so that the original will be delivered.
Range of (iR7200)
adjustment -10 to 10 (1 being equal to 0.5 mm)
<Using the Mode>
1) Make a print of the test chart, and check the position of the image.
2) Select the mode item, and change the setting to make adjustments.
3) Press the OK key.
4) Make a print of the test chart once again, and check to see the position of
the image is as indicated.
COPYRIGHT© 2001 CANON INC.
• A higher setting decreases the leading edge margin.
• The data is stored on the ADF controller PCB.
(feeding direction)
Higher setting
2000 2000 2000 2000 CANON iR8500/7200 REV.1 AUG. 2001
FEEDER>DISPLAY/ADJUST
Original
Lower setting
F00-302-01
SERVICE MODE
S-125