Transaxle Service; Transaxle Disassembly - Toro Workman HD Series Service Manual

Transaxle Service

Transaxle Disassembly

NOTE: Item numbers in figures are shown in order of
disassembly; for example, remove item 1 first, then item
2, etc. assemble transaxle in reverse order; for example,
install item 1 last.
1. Remove extension spring.
2. Loosen and remove flange head screws and remove
bell housing assembly from transaxle.
3. Thoroughly clean outside surface of transaxle.
4. Loosen flange head screws and remove fork shaft
case from center plate. Note location of longer flange
head screw. Be careful when removing cover as steel
balls inside are spring loaded.
5. Hold your hand over the area and shift R−1 and 2−3
levers to move rails outward so balls, springs and
spindle can be removed.
6. Inspect fork shaft case for cracks or damage and re-
place if necessary.
Workman HD Series
1
1. Extension
2
1. Flange head screw (1)
2. Flange head screw (3)
1. Spindle
2. Spring (2)
Page 6 − 23
Figure 24
2. Flange hd screw (9)
3
1
2
Figure 25
3. Fork shaft case
2
3
1
Figure 26
3. Ball (2)
2
2
Drive Train