3Rd − High Lockout Key Switch - Toro Workman HD Series Service Manual

3rd − High Lockout Key Switch
The 3rd − High lockout key switch has two positions:
SLOW (turtle) and FAST (rabbit). This switch is located
1
on the dash (Fig. 17).
Testing
2
The switch terminals are identified (Fig. 18). The circuit
wiring of the switch is shown in the chart below. With the
use of a multimeter (ohms setting), the switch functions
may be tested to determine whether continuity exists be-
tween the various switch terminals for each switch posi-
tion. Disconnect wire harness connector from 3rd − High
lockout key switch and verify continuity between switch
terminals.
NOTE: Switch terminals B and C are not used on Work-
Figure 17
man HD series vehicles.
1. Dash 2. 3rd−High key switch
POSITION CIRCUITS
SLOW B + C
FAST B + C, A + D
SLOW
45
FAST
After testing is completed, connect wire harness con-
nector to the 3rd − High lockout key switch.
Figure 18
Workman HD Series Page 8 − 15 Electrical System