Transaxle Service
Disassembly
NOTE: Item numbers in figures are shown in order of
disassembly; for example, remove Item 1 first, then Item
2, etc. Reassemble in reverse order; for example, install
Item 1 last.
1. Remove extension spring (Item 1).
2. Loosen cap screws (Item 2) and remove bell housing
assembly from transaxle.
3. Thoroughly clean outside surface of transaxle.
4. Loosen cap screws (Item 1) and remove fork shaft
case (Item 2) from center plate. Note location of longer
cap screw. Be careful when removing cover as steel
balls inside are spring loaded.
5. Hold your hand over the area and shift R–1 and 2–3
levers to move rails outward so balls (Item 3), springs
(Item 2) and spindle (Item 1) can be removed.
6. Inspect fork shaft case for cracks or damage and re-
place if necessary.
Drive Train
1
Page 6 – 22
2
Figure 25
2
1
Figure 26
2
3
1
Figure 27
Workman 3000/4000 Series