Toro Workman HD Series Service Manual page 129

10.Disassemble PTO intermediate shaft:
A. Use a bearing puller to remove bearing if neces-
sary.
11. Disassemble PTO output shaft:
A. Use a bearing puller to remove bearing.
B. Remove gear and retaining ring.
C. Remove retaining ring and thrust washer.
D. Use a bearing puller to remove bearing if neces-
sary.
Workman HD Series
1. Bearing
2. Gear
3. Retaining ring
4. Retaining ring
6
2
3
1. Bearing
2. Gear
3. Retaining ring
4. Retaining ring
Page 6 − 59
1
Figure 120
1. Bearing
Figure 121
5. Thrust washer
6. Bearing
7. Output shaft
5
4
Figure 122
5. Thrust washer
6. Bearing
7. Output shaft
Drive Train
7
1