Toro Workman HD Series Service Manual page 112

8. Assemble countershaft:
A. Use a press to install new bearings (item 15) onto
countershaft.
B. Install collar and snap ring.
C. Install washer and gear. Apply moly disulfide
grease into bushing of countershaft gear before
installing. Oil groove on washer must face the gear.
D. Install collar−spline and snap ring.
E. Install shifter onto collar−spline.
F. Install snap ring, washer and inner race. Oil
groove on washer must face the gear.
G. Install gear.
H. Install washer and snap ring. Oil groove on wash-
er must face the gear.
I. Install washer and a new bearing (item 1) using a
press.
Drive Train
1 2 4
16 3 5
1. Bearing
2. Thrust washer
3. Snap ring
4. Thrust washer
5. Gear
6. Inner race
7. Thrust washer
8. Snap ring (2)
7
5
6
4
3
2
1
1. Bearing
2. Thrust washer
3. Snap ring
4. Thrust washer
5. Gear
6. Inner race
7. Thrust washer
8. Snap ring (2)
Page 6 − 42
6 8 9 12 14
7 10 11 13 15
Figure 72
9. Hi−Lo shifter
10. Collar spline
11. Gear
12. Washer
13. Snap ring
14. Collar
15. Bearing (2)
16. Countershaft
11
10
8
9
8
14
13
12
Figure 73
9. Hi−Lo shifter
10. Collar spline
11. Gear
12. Washer
13. Snap ring
14. Collar
15. Bearing (2)
16. Countershaft
Workman HD Series
16
15