Toro Workman HD Series Service Manual page 123

31.Install R.H. axle shaft assembly:
A. Apply silicone sealant onto mating surface of seal
cover.
B. Install axle shaft assembly and secure with four
(4) flange head screws. Torque screws from 18.5 to
22 ft−lb (24.5 to 29.5 N−m).
32.Install L.H. axle shaft assembly:
A. Thoroughly clean mating surface of differential
carrier and side cover.
B. Insert selected shims into housing of side cover.
NOTE: The thickest shim should be installed
against the bearing.
C. Install axle shaft assembly and secure with flange
head screws. Torque screws from 18.5 to 22 ft−lb
(24.5 to 29.5 N−m).
Workman HD Series
1
2
1. Flange head screw (4)
1. Mating surface
1. Flange head screw (5)
Page 6 − 53
18.5 to 22 ft−lb
(24.5 to 29.5 N−m)
Figure 105
2. Axle shaft assembly
1
2
Figure 106
2. Shim
18.5 to 22 ft−lb
(24.5 to 29.5 N−m)
Figure 107
1
Drive Train