Inspection - Toro Workman HD Series Service Manual

Inspection

1. Thoroughly clean and dry all parts.
2. Use emery cloth to remove nicks and burrs from all
parts.
3. Measure clearance between groove on shift collar
and shifter block. Replace shifter block if clearance ex-
ceeds 0.039 in. (1.0 mm).
4. Measure I.D. of input shaft bushing. Replace bush-
ing if I.D. exceeds 0.673 in. (17.10 mm).
5. Measure O.D. of bushing area on input shaft. Re-
place shaft if O.D. is less than 0.667 in. (16.95 mm). In-
spect surface of bushing area for scoring or damage.
6. Inspect surface of oil seal area on output shaft for
wear or damage.
Workman HD Series
CLEARANCE
1. Input shaft bushing
Page 6 − 61
Figure 124
1
Figure 125
BUSHING
AREA
Figure 126
OIL SEAL
AREA
Figure 127
Drive Train