Headlight Switch - Toro Workman HD Series Service Manual

Headlight Switch

This headlight switch allows the headlights to be turned
on and off and is located on the dash (Fig. 10).
Testing
The headlight switch terminals are marked as shown
(Fig. 11). The circuitry of the headlight switch is shown
in the chart below. With the use of a multimeter (ohms
setting), the switch functions may be tested to determine
whether continuity exists between the various terminals
for each switch position. Disconnect wire harness con-
nector from headlight switch and verify continuity be-
tween switch terminals for each switch position.
SWITCH NORMAL
POSITION CIRCUITS
ON
OFF
After testing is completed, connect wire harness con-
nector to headlight switch.
Workman HD Series
OTHER
CIRCUITS
2 + 3 5 + 6
1 + 2 4 + 5
Page 8 − 11
1
2
Figure 10
1. Dash
BACK OF SWITCH
Figure 11
2. Headlight switch
Electrical System