Toro Workman HD Series Service Manual page 303

IMPORTANT: When installing female output hub as-
sembly into gear case, be careful to not damage the
seal in the gear case. The seal cannot be serviced
separately.
6. Press the new female output hub/bearing assembly
into the gear case from the inside. The bearing has a
slight interference fit to the bore, so it should not take
much force to press in. Take care to not damage the seal
during installation of the output hub assembly.
7. Place the gear spacer to the gear case and then
install the ring gear into the gear case.
8. Set the roller cage on a flat surface with the torsion
spring end facing up. Install nine (9) rollers into the slots
on the bottom row of the cage. If needed, use grease or
petroleum jelly to help hold the rollers in place.
Workman HDX/HDX−D
1
1. Gear case
2. Gear spacer
1
1. Torsion spring
Page 10 − 21
2
Figure 26
3. Female output hub
Figure 27
2. Lower roller
Front Wheel Drive (4WD)
3
2