Toro Workman HD Series Service Manual page 120

25.Measure countershaft end play. Rotate one of the
axle shafts back and forth to take up all back lash. Rotat-
ing the shaft in one direction will pull the shaft and bear-
ing away from the snap ring. Rotate axle shaft in this
direction, then measure space between the snap ring
and shim (set) with a feeler gauge. Make sure shim (set)
is held against the bearing during the measurement.
End play should be from 0.000 to 0.0039 in. (0.00 to 0.10
mm).
IMPORTANT: If end play is too large, replace shim/
shim set with thicker shims to reduce end play.
26.Insert sealing cap flush with face of housing. Make
sure to not insert sealing cap too far. Pay attention to
direction of sealing cap.
27.Install fork shaft case:
A. Insert spindle between fork shafts.
Drive Train Page 6 − 50
Figure 96
1
Figure 97
1. Sealing cap
1
Figure 98
1. Spindle
Workman HD Series