Toro Workman HD Series Service Manual page 47

Removal (Fig. 6)
1. Park vehicle on a level surface and engage parking
brake. Stop the engine and remove key from ignition
switch. Allow engine to cool.
2. Raise or remove the bed or other attachment(s). If
bed is raised, place safety support on lift cylinder.
3. Remove exhaust system components as needed.
4. Discard gaskets and thoroughly clean flange sur-
faces of exhaust tube and muffler.
Workman HDX−D
Installation (Fig. 6)
1. Replace any removed gaskets.
2.Fit all exhaust components to vehicle before tighten-
ing any fasteners. When securing exhaust, tighten fas-
teners in the following order:
A. Hex nuts that secure exhaust tube to engine.
B. Flange head screws and flange nuts that secure
muffler to exhaust tube.
C. Flange head screw that secures muffler to trans-
axle.
D. Flange head screws and flange nuts that secure
muffler to shift cable mount bracket.
E. Carriage bolts and flange nuts that secure muffler
to mount plate.
3. Lower or install bed or attachment(s).
Page 4 − 9
Kubota Diesel Engine