Front Wheel Drive (4Wd) - Toro Workman HD Series Service Manual

Front Differential Disassembly
1. Make sure that the oil is drained from the differential
assembly.
2. Remove the four (4) flange head screws from the in-
put cover. Remove the cover.
3. Remove the pinion shaft from housing by pulling it
out of the gear case by hand.
4. Inspect the inner pinion bushing in the gear case. If
the bushing is excessively worn, the gear case must be
replaced. The bushing is not serviced separately.
Workman HDX/HDX−D
1
1. Input cover
2
1. Pinion shaft
1
Page 10 − 15
2
Figure 11
2. Pinion shaft
1
Figure 12
2. Gear case
Figure 13
1. Pinion bushing

Front Wheel Drive (4WD)