Toro Workman HD Series Service Manual page 94

7. Loosen and remove fifteen (15) flange head screws
and separate center plate from transaxle case. Note
dowel pins in transaxle case. Remove seal cap, shims
and snap ring from center plate.
8. 4WD UNITS ONLY: remove front drive shaft and 41T
gear from the gear case. Remove bearings from gear
case and center plate (Fig. 28 and Fig. 29).
9. Remove reverse shaft from transaxle case.
Drive Train
3
1
1. Seal cap
2. Shims
4
1. Front drive shaft
2. 41T gear
1
1. Reverse shaft
Page 6 − 24
2
Figure 27
3. Shim
4. Snap ring
1
2
Figure 28
3. Bearing (gear case)
4. Bearing (center plate)
Figure 29
2. Bearing (gear case)
Workman HD Series
4
3
2