Toro Workman HD Series Service Manual page 97

17.Remove washer from inside of transaxle case.
NOTE: Washer may stick to fork shaft when removed in
step 16.
18.To remove shift arms:
A. Loosen and remove nut. Remove 2nd−3rd shift
arm together with shift arm plate, spring, lock nut,
washer and cap screw.
B. Loosen and remove lock nut from both 1st−Rev.
shift arm and High−Low shift arm (not shown). Re-
move shift arms.
C. Loosen cap screws (Fig. 38) and remove keeper
plates.
D. Remove oil seals.
E. Inspect shift arms and keeper plates for bending
or damage and replace if necessary.
Workman HD Series
1. Nut
nd rd
2. 2 −3 shift arm
3. Shift arm plate
4. Spring
5. Lock nut
12
11
10. Cap screw
11. Keeper plate
Page 6 − 27
1
Figure 36
1. Washer
1
3
7
6
5
4
2
8
9
Figure 37
6. Washer
7. Cap screw
8. Lock nut
9. 1st−Rev shift arm
10
Figure 38
12. Oil seal
Drive Train