Toro Workman HD Series Service Manual page 115

11. Assemble reverse shaft:
A. Install gear onto reverse shaft.
B. Use a press to install bearings.
12.Assemble main shaft:
A. Install gears and snap ring.
B. Install gear.
C. Use a press to install bearing.
D. Install washer and needle bearings onto main
shaft. Apply moly disulfide grease onto washer and
needle bearings before installing. Oil groove on
washer must face the gear.
E. Install gear and snap ring.
F. Install synchro ring onto gear. Apply clean Dex-
ron III transmission oil on cone face of gear before
installing synchro ring.
G. Insert key.
H. Install synchro hub sub−assembly.
I. Install snap ring.
J. Install synchro ring onto gear. Apply clean Dex-
ron III transmission oil to cone face of gear before
installing synchro ring.
K. Insert needle bearings into gear. Apply moly dis-
ulfide grease onto needle bearings before installing.
L. Install gear with synchro ring onto main shaft.
M. Install washer and snap ring. Apply moly disulfide
grease to washer before installing. Oil groove on
washer must face the gear.
Workman HD Series
3
1. Bearing
2. Gear
3 4
19 1 2
1. Bearing
2. Snap ring
3. Washer
4. Gear
5. Needle bearing (2)
6. Synchro ring
7. Snap ring
8. Shifter
9. Key
10. Snap ring
4
5
2 3
1
10
7
1. Bearing
2. Snap ring
3. Washer
4. Gear
5. Needle bearing (2)
6. Synchro ring
7. Snap ring
8. Shifter
9. Key
10. Snap ring
Page 6 − 45
4
Figure 80
3. Bearing
4. Reverse shaft
7 8 10 13 16
5 6 9 11 12 18 17
Figure 81
11. Gear
12. Needle bearing (2)
13. Washer
14. Bearing
15. Gear
16. Snap ring
17. Gear
18. Gear
19. Main shaft
8
6
9
19
13
12
11
6
Figure 82
11. Gear
12. Needle bearing (2)
13. Washer
14. Bearing
15. Gear
16. Snap ring
17. Gear
18. Gear
19. Main shaft
2 1
14
15
14
16 15
18 17
Drive Train